PE plastic sheet surface how to film?
First of all, you want to tear off, that is to say, the film should melt into the board, so it must be the film in the mold out of a plate where the beginning of the cover. Add a pneumatic shaft in front of the first roller to cover the film roll. Then, every time you change the film volume, the front ten meters or less.
Once again, attached to the film thickness should be moderate, too thin, easy to burn, pull off, too thick, can not be completely integrated with the plate.
Second, you should figure out the material properties of your plate itself. And you want to put on the membrane, two kinds of material compatibility?.
