What is the control principle of the pneumatic three jaw chuck? How does the pneumatic component control the chuck, then how does the chuck connect to the spindle? If a satisfactory answer will chongxie! most
The 3 claws move synchronously to the center, clamping the target workpiece, and when the electromagnetic valve is powered off, the 3 claws will be released simultaneously and reset. In order to solve the gas claw used in rotating occasions, you can use the "rotary joint", is 2 in 2 out of that, one end of the rotary joint is connected with the gas claw, the other end is connected with the fixed end, that can achieve the rotation function of gas claw.
You can only answer your previous question. How does the pneumatic component control the three jaw chuck?:The three jaw chuck is also a kind of cylinder, but the connecting rod is added to the piston rod of the cylinder to form two claws or three claws.So the pneumatic component is the principle of controlling the air claw, the same as the principle of controlling the cylinder
Three pneumatic catch the name chuck is not exact, the real name of the pneumatic chuck is "gas claw", there are three gas claw 2 claw, 3 claw and 4 claws, you said 3 claws, actually this is used in the same way as with the cylinder, using a 2 bit 5 way solenoid valve can control (single coil can), when the solenoid valve power
