Safety operation of hydraulic platform
Don't overload your operations; Try to be as special as possible; Try to troubleshoot the professionals if possible. In conclusion, the operation of strict accordance with the operating procedures provided by the manufacturer is the main body of the security guarantee
4, rise and fall: press the "rise" button, start the motor, the motor spin, the hydraulic system work, the oil cylinder protruding, the platform rises. Stay up to work the required height, "stop" button, the motor stop lifting platform, can work, if not in accordance with the "stop" button, the platform to calibrate height be 8 meters (native) trip switch, platform in height. At the end of the work, press the "drop" button, the solenoid valve action, when the oil cylinder is turned on, the platform is lowered by itself. During the use of hydraulic platform, it is strictly forbidden to overload (the unit load is 300kg), and the operator on the platform will not be moved during the descent. When moving or traction hydraulic platform, the supporting leg should be collected and the platform will be lowered to the lowest position. 7, when platform malfunction cannot work normally, should be promptly cut off the power supply for repair, it is strictly prohibited to equipment to work, in spite of non-professional workers do not remove the hydraulic components and electrical components. Do not use the machine in an unstable condition on the ground. Please do not raise the platform without the platform, the outside legs are not adjusted, the platform is flat and the ground is unstable.
Purpose: this procedure is used to guide operators to operate correctly and use hydraulic platform equipment. Two procedures: 1, the parts should be inspected carefully before they are work lifting platform, key check whether the screw connection is reliable, hydraulic pipe leaks, loose wires contact with and without, breakage, and so on and so forth. 2, lifting platform lift, put the leg in the four corners, four leg should be firmly supported on solid ground, dispatch work mesa to state level (visual). Turn on the power, the indicator should be on. Then start the motor, pump work, drop one or two in the air, check the parts and then start working again. When the temperature is below 10 ℃, should make the pump running 3-5 minutes, confirmation of oil pump work can be carried out. 3, homework personnel enter the platform after the guardrail doors should be closed, with bolt, tied on safety rope, the center of the load (people stand location) should be in the center position of workbench face.
The driver shall be responsible for monitoring the distribution of the goods on the platform as uniformly as possible to prevent partial load and to prevent overload operation. The platform does not allow people to carry dangerous goods, such as inflammable and explosive devices, and to ban people from climbing as they rise, as well as artificial shaking. Drivers in the platform are strictly forbidden to leave their posts and to wipe, lubricate or repair the platform. When the work is finished, the driver should cut off the power supply and lock the control panel to leave the job and fill in the record of the transfer. 31 malfunctions, platform, or lose the normal work, should immediately notify the maintenance personnel to repair, if found to have dangerous or may cause personal mechanical accident, should immediately stop using, the total power cut off room and report to management department, just can use after repair and check in detail.
