Home > categories > Furniture & Décor > MFC Executive Desk > The difference between a large board and a plywood
Question:

The difference between a large board and a plywood

The difference between a large board and a plywood

Answer:

Buy large core board, must buy regular manufacturers of E1 products.Choose to observe its appearance, see big core board surface is smooth, without warping, deformation, there is no bubble, depression, the best can be opened the article core observation internal is uniform and tidy, the smaller the gap, and should not have decayed, fracture, wormhole, knot etc..Buy Daxinban, businesses tend to have many piles of stacked Daixinban a picture, can choose new Duitou (ashLess, wood color new) put a few of its big core board up, fan about, smell the taste of the drift out, without stimulation, environmental protection is relatively good.
The vertical direction of the core plate (the difference between the core and the material) is poor, but the lateral flexural strength is higher. Both nail grip and water repellency are availableBetter than MDF and chipboard. The surface is generally rough and needs finishing (paint or decorative panels etc.). Simply speaking,A large piece of carpentry that must be nailed at home usually requires a large core board.But the large board itself uses a lot of glue, and a lot of glue or paint will be used in the finish, and the core boardPollutants are in open volatile state, so, home improvement must strictly control the use of large core board.
Plywood English: Plywood plywood is made of wood or wood, sliced into thin wood, cut into thin wood, and then glued into three or more than three layers of sheet metal. Usually, the odd layer single plate is used, and the fiber direction of the adjacent layer single plate is mutually arranged vertically and glued. Therefore, there are three, five, seven, and so on odd layer plywood.Structurally, the outermost veneer of plywood is called a watch board, and the front panel is called a panel. It is made of the finest quality veneersMaterial. The reverse plate is called the backing plate, and the quality is the second sheet. The inner sheet is called the core plate or the middle plate, and it is made of the single sheet with the worst quality.
Big core board is also called blockboard, is in the middle of the two pieces of wood veneer splicing board and clamp. The wood and wood veneers in the middle are made of adhesive glue, so the formaldehyde release of many large core boards is beyond standard.

Share to: