The kitchen lights in my house are broken! Ceiling lights are with the buckle board together, do not know where to start out, I would like to ask you how to get big? Need tool not? Thank you! anxious
Do not need tools, my family is also bad, above the card, hand down can be moved down,
If it is the side of the aluminum plate, it is very simple, with a pass through the sewer of the child (chuāi zi) suction ceiling lamp near the center of the buckle, pull down, you can put that buckle off, If the plate there is a side of the keel caught in the folder sandwiched, to reach out and press the side there, in short, to close the buckle that off. The next step, reach out, the ceiling of the gongs are clamped by the keel of the two sides press down, you can put the ceiling of the buckle plate unloaded, for a good light after the buckle up as the original ok.
This depends on the type of ceiling board to choose the appropriate solution. Specifically, it is divided into the following two cases:
1, the ceiling of the board for the square board (the general specifications in the 30 cm or so square), first remove the ceiling next to a square plate, using a wallpaper knife blade into the ceiling lamp and the surrounding square between the gap of a certain size And then the blade will pry the square around the ceiling lamp and then take the board from the side of the side where the board has just been leveraged. After the ceiling of the connection to the wire to be replaced after the replacement of ceiling lights. To be finished after the lamp, and then re-install the square board can be removed just.
2, the ceiling of the board for the board (that is, long strip), to remove the ceiling lamp, you need to ceiling lights on both sides of the strip on both sides of the buckle first removed, and then take the board and change the lights.
