The operation procedure of forklift truck
(4) loading and unloading (1) fork materials, should according to need to adjust the distance between two goods fork, make the two forks load balancing, not skewed, items side should be posted on the shelves, fork in weight shall comply with the provisions of the curve of load center sign. (2) the carrying capacity shall not obstruct the sight of the driver. In the course of loading and unloading, the brake forklift must be used. (4) when the goods are approaching or exiting the goods, the speed should be slow and steady, and the wheel should not be rolled over the items, wooden pads, etc., so as not to be crushed by the roller. (5) when taking goods with a fork and fork, the cargo fork should be as deep as possible in the load, and the tip of the fork cannot touch any other goods or objects. The minimum door frame should be used to stabilize the load, so the load will not slide backward. When the load is put down, the door is small enough to allow the load and the fork to be drawn. (6) the high speed forked goods and the collision between the fork and the hard object are prohibited.
(3) the driving (1) when driving, the bottom of the fork should be kept at 300 to 400mm and the door frame will be tilted back. Do not raise the fork too high when driving. When traveling in or out of the job, pay attention to whether there are any obstacles to be touched. When driving, if the fork rises too high, it also increases the overall height of the forklift truck, affecting the stability of the forklift truck. (3) after unloading, the cargo fork should be landed before moving again after the normal driving position. (4) when turning, if there are pedestrians or vehicles nearby, they should send a signal and stop the fast turning. A sharp turn can cause the vehicle to lose its horizontal stability and tilt. (5) the internal combustion forklift truck is strictly prohibited from coasting while downhill. (6) in the case of special circumstances, it is forbidden to brake on the carriage.
1) check the vehicle Before (1) forklifts, the appearance should be inspected, and the fuel, lubricating oil and cooling water should be added. (2) check start-up, operation and braking performance. (3) check the lighting and sound signal to be fully effective. (4) the forklift should check the pressure and the temperature is normal. (5) after the operation of the forklift truck, it should also check the leak and replace the sealing part in time. (6) the electric cylinder forklift should check the contents of the electric car and inspect the circuit of the electric bottle forklift
