My home has a 40L electric water heater, I would like to know its working principle, in order to facilitate the use of electricity conservation.1 how do you know how much hot water there is?2 whether it is in hot water, cold water has been injected into the water heater3 there are several water heaters in the water heater. How do they distribute the work?Well, I'm not very good at it. Please ask professional people to help me out
I'll tell you the truth: it's not as complicated as you think it is. It's super simple! ?The water heater as a cylinder, cone bottom left (outlet is connected with the thickness of a finger through the pipe to the top of the tank, the length is slightly shorter than the tank diameter) on the right is the water inlet (inlet pipe only 2-3cm long)Because the water density is small, is always floating in the upper heating tank, cold water from the bottom of the hot water from the outlet pipe by extrusion extrusion, in the upper part of the tank opening, so that the hot water is squeezed into the outlet pipe, for your bath out from the water outlet nozzle! ?My shower is 60L, usually wash your face and wash your hands without any problem! It's not enough to warm up to 45 degrees! ?If you're ready to take a shower, 40L's water heater goes up to 65 degrees. I think it's more appropriate. (as youI have here the indoor temperature, heating, 22 degrees)The lower the temperature setting, the more energy saved!
Therefore, the hot water is squeezed into the water outlet pipe and is brought out from the water outlet nozzle for people to bathe. Because the water inlet and outlet of the water storage electric water heater is replaced by cold water, the water temperature in the water storage space is accelerated. At present, some electric water heaters are equipped with a fast heating device, internal partitions and other designs, reducing the consumption of cold and hot neutralization, and ensuring the water temperature of many people bathing.
The bottom of the inner liner of the electric water heater is provided with tap water, and the original hot water in the water tank is pressed by the tap water pressure, and the hot water is extruded from the upper part. As the hot water density is small, heated, always floating in the upper part of the tank, the cold water from the bottom into the hot water extrusion squeeze, from the upper part of the tank outlet pipe into the mouth
