Home > categories > Consumer Electronics > USB Flash Drives > The Toshiba U disk cannot be read and can be detected.
Question:

The Toshiba U disk cannot be read and can be detected.

My U disk is Toshiba 16G USB3.0U disk, after a use, suddenly can not use. Plug into the computer, turn on my computer and show the removable disk, but there's nothing in it. The computer prompted formatting, but the formatting failed.

Answer:

There's something wrong with the U disk. Try it in the following way:1, formatting in computer administration. Right click on my computer, select management, open the computer management window, select disk management, select the U disk, and format the U disk. The data on the U disk is gone.2, with USBoot and other similar software repair.3, to the U disk home download the corresponding U disk repair tool, repair.4, the above method is invalid, using mass production tools U disk production. U disk production is very troublesome, and not necessarily a success, often many times to succeed. The first ChipGenius (chipgenius) view U disk master model, you can open the U disk shell view U disk chip model, sometimes the detection software allowed detection, directly view more accurate; then according to the main control model, download the corresponding production tools, not necessarily the most new production tools, installation of production tools; operation production software, production of U disk. Production tool is the ultimate weapon maintenance U disk, as long as it is not a hardware failure, with almost 100% production tools can be repaired, but the production tests tend to be successful, can a few more production tools, you must go to the online course.
Method one:Download the Usboot tool (disc ghost system this tool is very classic with a large online search), formatted by the way of HDD, which need to insert the USB and then follow the prompts to pull off, finally complete boot disk creation. This time you can double-click on the letter, prompted to format. Then click "yes", finally saw the long window select FAT format, format, everything is completed, USB to can be used normally, no capacity loss. There are also problems of friends can try this way, of course, the situation could not be formatted USB vary widely, if not flawed, total solution. Hope to be useful to everyone.Method two:To manufacturers with a U disk chip corresponding production tools software (or online search download), using production tools software formatDownload ChipGenius is U disk main control chip detection tools, such as the detection of the main control chip is "CBM2091" and "CBM2091" in the online retrieval, find the CBM2090CBM2091 production tools, after the operation of U can be detected in the flash disk, set inside the scanning mode is set to a lower scan and check to format, aging, determined after the election all began, then began scanning and formatting U disk, U disk watch non-stop flash, know the repair is not a problem.
Try another USB interfaceTry changing computers
If the U disk does not have any important files, format your U disk first and plug in to see what the system prompts. If you can open it, you'll be fineIf it can't be used again, drive it from the new USBIt could be the cause of the virus. You can try to restart your computer after all anti-virus

Share to: