The upper and lower bunk beds are assembled after disassembly
Disassemble through the three in one connector.The vertical connection between panel furniture and board, some special connecting parts can realize the horizontal connection of two boards, and the three plate interactive connection, generally used for MDF, MDF, particleboard.
Open the package, take out all the parts, screw nuts, two enterprises, one ladder (bed ladder) rubber sleeve, the rubber sleeve two bedstead mounted to the frame tube in enterprises (install the rubber sleeve is played and anti noise) installed in bunk beds in Dongguan if there are two people, a person holding a business frame, and they take a bedstead (if there is a person, first of all enterprises to set up against the wall frame wearing screw, screw wear in enterprises to pick up another frame set on), attention is at the top of the fence, do not install the wrong, another point to note that the two ends of the ladder hole to align the bed of both sides, do not get back. You can't install the ladder after you've got it back. Screw up the screws and tighten them. The bed board is installed.
The three in one is made up of three parts: three in one, equivalent to the nail and slot structures in the traditional woodwork. They are the three parts: the eccentric core (also called eccentric nut, eccentric wheel, eccentric parts, etc.), connecting rod (bolt), embedded nut (swelling bolt, plastic commonly known as plastic particle). The advantages of the three in one connector are as follows:1, embedded nut: reinforcement special; connecting rod: connection special; partial heart: solve the locking problem between plates. Through the bolt, the bolt, the eccentric combination of three in one connection, firm.2, three in one connection can be repeated disassembly. This is also one of the advantages of panel furniture.3, hidden. No three in one connector can be seen from the outside surface.4, three in one connection, reducing the use of adhesives. More environmentally friendly.
