Home > categories > Electrical Equipment & Supplies > Uninterrupted Power Supply (UPS) > UPS power supply can not be charged? How to solve
Question:

UPS power supply can not be charged? How to solve

I use the GES-V1200 UPS power supply, has been in use, the computer every day in the boot time are more than 10 hours, about 2 months before the sudden power failure, UPS can work 10 minutes, the day before yesterday, power outages , UPS immediately issued a "drop" tweet, a few seconds, UPS power out, I feel doubts: UPS open time every day, but not short ah, how will it no electricity? Yesterday, I discharge and then charge, only to find the UPS even have a little bit of point, immediately put over, at night I filled 10 hours, today up with, or a little bit of electricity, no power on it, but as long as the electricity, UPS But also normal work, the computer can also be a normal boot, that is, a power, flew off, how can the UPS charge the power? Please enlighten me master, thank you, do not know how to answer

Answer:

Oh ... ... brother, your UPS for the battery. Specifically, you usually do not maintain enough As you say, usually UPS has been in a state of charge. right? You open the UPS internal look, the battery may have been up, or deformation. Change the battery bar. Change the way to call people to give you what the normal charging voltage test? If too low, the battery has been full, if high, resulting in the battery charge hot, leakage deformation, are possible. After the change should pay attention to maintenance. Like you this kind of UPS, if the week did not stop the electricity, then the last manual unplug the utility plug, let the battery work about. How long does it take to see your UPS load. Remove the battery capacity of one-third of the OK. good luck.
Let him rest and rest your battery waste can change the battery

Share to: