Home > categories > Hardware > Screws > The cross screw of the cross screw was polished and how the screws were unloaded
Question:

The cross screw of the cross screw was polished and how the screws were unloaded

Very urgent, please help a lot. I do not have any advanced tools, only the screwdriver or something

Answer:

Use a 502 glue to stick the screwdriver above it and then twist it down
Find the same impact with the screw cross the size of the mold head, with a hammer hit the impact of the screwdriver can be removed to cross the brush almost screwed. The
You can use the pliers to turn down the twist can also be opened with a saw blade
Drop a few drops of a little bit of lubricating oil, a few minutes ... if it is able to use the hand saw the lower edge and then use the vise to twist the edge to turn out; if it is embedded, is it possible to use a hand drill or a small screw Batch on the nail cap to open a slot, and then almost the same screwdriver unscrewed try
First with a diagonal pliers to screw out the word screwdriver of the gap, you can also use the saw blade, if it is embedded in the shell can only use the diagonal pliers. This solves the problem of the screwdriver, the next step is to twist, and use a diagonal pliers or other tools to insert the bottom of the screw cap, so that the pry can come out.

Share to: