Home > categories > Machinery & Equipment > Welding Rods > Welding rod heat preservation barrel should be clamped in the welding machine
Question:

Welding rod heat preservation barrel should be clamped in the welding machine

Welding rod heat preservation barrel should be clamped in the welding machine

Answer:

The output terminal of welding machine (or welding machine quick socket) is suitable for welding electrode barrel.
The wire end can be used with the insertion of the electrode insulation barrel insulation barrel, the other end two clips are respectively clamped in a quick connector holder, on the ground. The above is nonsense, since you ask, I estimate you are far away from the welding operation machine, can not be used with a wire insulation barrel. There are two solutions: 1. the insulation barrel comes with wire clip extension cord is cut off; 2. comes with a wire end clamp bare wire in wire, welding tongs plastic handle truncated, the wire clip in the wire holder. In short, to form the current loop can be.
The electrode holder is clamped on the output terminal of welding machine (or welding machine quick socket).Electrode holding barrel:First, the use of methods:Put the baked electrode into the barrel and take it with you. If the cooling, with the original plug a clamped welder + pole, a clamp of electric welding machine, can be heated.Two. Why should it be kept warm?:Heat preservation is to keep the electrode dry. In the workshop, some electrodes are afraid of moisture, and wet welding electrodes will affect the quality of welding. Therefore, after baking the electrode placed in the heat preservation cylinder, with the use of take.

Share to: