When the engineering plastics in the processing, because it is not often around breaking chip, tool and workpiece, not only affects the working efficiency, but also the workpiece surface galling, do not know can not think of a way from the cutting tool and cutting amount? Who can give me some good advice? Please.
Angle of feed, generally use 60 degrees bevel angle, the amount of cutting does not exceed 1MM. Also, adjust the cutting speed.
Superfine base material, uncoated blade and forced chip breaker can be used.
Angle of feed, generally use 60 degrees bevel angle, the amount of cutting does not exceed 1MM. Also, adjust the cutting speed.
Angle of feed, generally use 60 degrees bevel angle, the amount of cutting does not exceed 1MM. Also, adjust the cutting speed.This answer is very good, the landlord can adopt.From: Xushui engineering vehicle network.
