What are the paving process of artifical grass?
Before entering the construction of artificial grass products, first of all to flat on the ground, slope degree and surface impressions were detected, such as leveling and the degree is not up to the index, you need to for the rectification of the site, to achieve the above requirements before entering the construction;
When the grass paving assembled and turf folding part need to paper cutter opening, straighten the docking, overlapping part resection and cementation. Combing with the brush grass turf all the adhesive after: the first times with grass brush the whole lodging grass line comb stood up.
After the turf of basic assembled again pull out the exact location of the line, point, with a knife to cut paper cut, out of cut grass strip, will be connected with into, scraping glue, originally prepared white grass line back, after cementation, beat repeatedly with a rubber hammer to ensure tight junction part of the bond
The turf moved admission along the direction of a sideline spread out, and ensure that the A1 roll grass woven white line and the bottom line is consistent, then the volume of turf in turn by the end of the line to the other end of the propulsion. At the same time, need to ensure the A14 and A15 volume turf in the white line of the middle and consistent, A28 volume grass skin white and the other a bottom line coincide, in the spread of turf in the process that minimize the wrinkle appears
On line measurement, find the center point of the site and the two semicircle circle, and on the basis of the three positioning points pull foot line, make appearances in the midline and sideline intersection, and Pythagorean theorem is used to set the exact position of the field angle, point, line, and then set the location of the point, line, and with ink or paint line pop-up.
