What are the steps to inflate the tires of a truck? What problems should I pay attention to?
1, inflatable should pay attention to safety. Always use the barometer to check the air pressure to prevent excessive inflation and to cause the tyre to burst.2, after stopping running, to heat the tyres after inflation, because traffic will increase when the tire temperature, the pressure effect.
Summer takes 8-10 pounds (0.8Mpa-1.0Mpa).10-12 pounds (1.0Mpa-1.2Mpa) in winter.Pound is our customary term here. You can measure Mpa values with a tire pressure meter.If the driver requests different air pressure due to different loads. (of course, the tyre burst is none of your business)In safety, you would have to inflate the tires, but most drivers require heavy inflation. You should pay attention to the quality of the tires. Be careful of the tires and yourself
6, before the air should be dust valve mouth clean, do not loosen the valve core, the valve on the water filling with soap after completion, check whether the leak (leak if it will produce a small bubble), and the valve cap with impaction, prevent the sediment into the valve inside the mouth.7, radial tires inflated, due to its structure, the subsidence, ground area were larger, often mistaken for inflated and excessive inflation; or on the other hand, because of the subsidence and the ground area was larger in low pressure also has plenty of mistaken. Measured by a standard barometer. Radial tire pressure should be higher than the average tire 0.5 ~ 1.5kg / square centimeter
3. Check the valve. If the valve and valve core do not match properly, the phenomenon of protruding concave and other defects can not be inflated and air pressure is measured.4, inflatable should pay attention to cleaning. The filled air shall not contain water or oil to prevent deterioration or deterioration of the rubber in the inner tube.5, the inflatable should not exceed the standard, then deflated, nor can not be inflated due to long-term outside can not be inflated. If more than the standard is too much, it will lead to excessive extension of the cord, causing its strength to reduce, affecting the tire life.
