What are the two types of cutters that are divided according to the clamping methods? What milling machines are applicable to each?
The disc mill installed through the hole applies to horizontal milling machines. The end face and rod milling cutters installed by the handle are suitable for vertical milling machines.
Most of the milling cutters in the machining center are equipped with a spring clip and a set of clamps, and they are in a cantilever shape when used. Is the process of milling cutter, may sometimes appear from the knife clip out gradually, so that the complete loss, so that the workpiece scrapped? Sight, its reason is due to the general deposit is oil film between the cutter holder and the hole of the outer diameter of the milling cutter, the clamping force is not enough due to the formation of. Cutter factory are generally coated with anti rust oil, if cutting using the non water soluble cutting oil, the tool holder hole will be attached to a layer of fog oil film, sell the knife handle and the knife clip there is oil film, the knife clip is difficult to handle is firmly clamped, machining cutter on the super loose? Lost. Therefore, before the milling cutter is installed, the milling cutter handle and the inner hole of the cutter clamp shall be cleaned and cleaned, and then they will be clamped after drying.
