Home > categories > Construction & Real Estate > Ring-lock Scaffolding > What is the horizontal spacing of the wall of the bowl buckle scaffold
Question:

What is the horizontal spacing of the wall of the bowl buckle scaffold

What is the horizontal spacing of the wall of the bowl buckle scaffold

Answer:

For the double row scaffold with a height of 24m or above, it is necessary to connect the rigid wall with the building. 6.4.5 wall construction shall meet the following requirements: (1) the wall of the wall connecting rod or horizontal reinforcement should be set, when not level settings, and end connections shall be connected by scaffolding, should not be used on cable connection; (2) the wall must be constructed by tensile and pressure. The reinforcement must be matched with the supporting and supporting should be reliable at the top of the concrete ring beam, column structure. Steel wire should be used for more than of the diameter of the steel wire twisted into one, the use should not be less than 2 shares; can also be used not less than 6mm diameter reinforcement. 6.4.6 when the lower part of the scaffolding can not be set up even when the wall can be set up throwing support. Throwing support should be used in long rod is reliably connected with the scaffold, and the ground inclination should be between 45 DEG ~60 DEG; the connection point to the main center node distance should not be greater than 300mm. The support shall be removed before the wall parts are erected. When the height of the 6.4.7 frame is over 40m, and the wind vortex is acting on the wall, the measures of anti roll up wall should be adopted.
From the bottom first step longitudinal rod set, when there are difficulties of the setting, should adopt other measures reliable fixation; (3) should give priority to the diamond arrangement, also can use square, rectangular layout; (4) at both ends of a type, open type scaffold must be set with the wall, the wall of the vertical distance should not be greater than the building height, should not be greater than 4m (2). 6.4.3 to the height of 24m in the following single, double scaffolding, should be used to connect the rigid wall and reliable connection of the building, can also be used to pull the ribs and the roof with the use of wall attached. It is strictly prohibited to use only the flexible wall pieces.
Need to give you a standardized system to learn about ah? The arrangement of the wall parts shall meet the following requirements: (1) should be close to the main node, the distance from the main node should not be greater than 300mm;

Share to: