I have a molle 3 day assault pack and a sog seal pup elite what else should I have in there
these parts are avil at most good hardware's,,,,,,,put nut on,put ferrule on,,push tubing all the way in,hand tighten,tighten with wrench till good and snug,all the while pushing on the tubing
The hardest and most expensive part of fixing the gas heater is the flueBut it is not extravagantTo raise it off the floor is no big dealYou can build a platform or purchase one from a supply house already pre-madeI don't understand why copper is not allowed, unless it is from an iron pipe manifold that the gas is supplied through and there could be a requirement for them to use a flexible connectorStill not a big deal nor expenseWeigh that against the cost of running a new electric outlet for an electric heaterAs mentioned, you may want to consider taking a credit from the seller and purchase a tankless heaterGas or ElectricIt will be less energy used down the roadGood luck
This Site Might Help YouRE: any tips for installing a ferrule nut on water heater? I just tried to do it and the tip failed to cramp with the tube and the whole thing was a big failure, luckly I'm getting a replacement sent to me (2 more days with no hot water) here is what I did, let me know where I went wrong and any tip you could provideFirst I hand tighten the nut.
