What should I pay attention to when learning the loader?
Four often: that is, in the loader operation, especially loader in the excavation work in case of resistance, do not use the accelerator to control the vehicle condition. Still should be in the case of steady throttle, with the cycle of moving up and turn bucket control lever method to make the loader to maintain normal working conditions, and bucket shovel full of materials. Because of the need for work, lifting and turning the lever of the bucket is what we call "diligence"". This process is very important, and the amount of fuel consumption is critical in the operation of these operations, which should be paid special attention to by operators. Five coordination: coordination is the organic coordination between lifting and bucket control levers. In general, the backhoe process of the loader is that the bucket is flat and the slope is stationary towards the pile. When the bucket is parallel to the hopper, there is resistance, the first should follow the principle of first lifting the arm and then receiving the bucket. This can effectively prevent the formation of the bottom and the ground resistance of the bucket, which can give full play to the maximum breakout force. This kind of parallel operation solves the smoothness of the work site, the comfort of the driver and the unsafe factors in the workplace, and does not often have to clean the work site alone. The utility model reduces the time for leveling the site alone, increases the effective workload, improves the work efficiency and saves oil. In the arm and the rotating bucket lever of organic coordination work, make full use of the loader digging force, lever coordination properly, even the light throttle can also smoothly make the bucket full of material.
Note: learning learning loader loader do: a light two stable; three from four, Qin; five coordination, six prohibited. A: that is in the loader cab floor abutting the heel, foot and the accelerator pedal to keep parallel. Gently press down the oil pedal and always keep the pedal under pressure. In this way, the fuel can be fully burned, and when the operation is not too large, the accelerator makes the driver's foot heavy and hand disorderly. Two stability: Loader in the work, always keep the throttle. Under the general working condition, the maximum throttle is about 70%. This can make the machine in the work of people like jogging as "uniform breathing" and can greatly reduce fuel consumption, thereby prolonging the service life of the machine, but also benefit in this work naturally reflected. The advantage of the question is to reduce the loss at all times and achieve long-term economic results. Three off: that is, during the loader operation, the feet should be separated from the brake pedal and flat on the cab floor. Never step on the brake pedal. The working environment of loaders is often on uneven work sites. If the foot is treading on the brake pedal for a long time, the driver will inadvertently brake automatically due to the movement of the car up and down. Under normal circumstances, use the throttle deceleration method to control the car condition and shift gears. In this way, the brake system overheating caused by frequent braking is avoided, and the quick speed increase of the loader is also convenient. It avoids a series of seemingly difficult problems, such as the heating and braking of the disc when the brake system is overheated, and sometimes the phenomenon of braking, as well as the braking, afterburning, pump running, oil and so on.
