I have a solar panel i got for free and I don't know what to do with it. Its kinda big at about 20x 0and it puts our 2 VOC / .23 ISC. I don't know of anything that I could use it for. Its too big to say charge a phone or ipod....any suggestions??
Makes a great charger for a boat or car battery. I have one about that size that I have mounted on the fishing platform of my boat. The trolling motor battery is always fully charged when I need it.
Hey AJ, Tom is quite right, a panel that size is a great trickle charger at .2 amps. If you have a good sized 2 volt battery, like from a truck, or for a boat trolling motor (it should be at least 60 amp hours) you can hook it to the battery and it will charge it slowly anytime the sun shines. Don't worry about the voltage, most 2 volt nominal volt panels are wired for 8 - 9 volts, and if you hook them to a battery, the panel voltage comes right down to the batteries charging curve voltage anyway, they are designed for that. What you do need is a diode. A diode is an electrical check valve, allowing current to flow in one direction, but not the other. This will prevent the battery from discharging through the panel at night. Many panels today come with diodes inside the junction box on the back of the panel. If yours does not have any, go to Radio Shack, look for a 6 amp silicone diode, usually around75 cents. Put it in series between the panel and the battery, then, while you have a voltmeter hooked to the battery, connect the panel/diode to the battery and see if the voltage goes up slightly. If it does, you're all set. If not, turn the diode around and try it again. It has to be connected into the circuit the correct direction. Many people will state that you need a charge controller, but this is not necessary if your panels max current, ISC is less than 2% of your batterys amp hour capacity. In your case, if you have a 60 AH or larger battery, skip the controller. There is a great discussion about this in Richard Perez's book, I will list it below. If you want to learn more about these devices, there is a great magazine that gets into the nuts and bolts of renewable energy, it's called Home Power Magazine, the link is below. We started by hooking a slightly larger panel to some golf cart batteries 2 years ago, reading that magazine and going to some energy fairs. Today our home is completely powered by the wind and sun. Check it out sometime. Take care, Rudydoo
2 volts rate at .23 ampere. It can be used to charge car battery. Put a 5 ohms rated 0 watts resistor in series between panel and 2.6 volts car battery to lower its voltage.
Solar cells convert the energy of the sun into electricity. By using items commonly found in the home or your local hardware store, you can make a solar panel to demonstrate this photoelectric effect. You can also save energy by converting some of your traditional electrical supply over to solar power. Use sheet metal shears to cut the copper flashing in a square or rectangle to fit the size of the electric burner. Be sure to use a piece of copper flashing that is thoroughly cleaned. You may use sandpaper to thoroughly remove any sign of corrosion before proceeding. Place the copper flashing on the electric burner and turn the burner on. You will need to cook the flashing for as long as 30 minutes or more to develop a thick layer of black cupric oxide.
