Home > categories > Construction & Real Estate > Cement Boards > when installing cement boards on my bathroom walls is it ok to screw them on directly?
Question:

when installing cement boards on my bathroom walls is it ok to screw them on directly?

when installing cement boards on my bathroom walls is it ok to screw them on directly?

Answer:

Directly? It is recommended to attach with screws into studs as specified for the material, so many inches apart. How would you atttach them otherwise? Do the seams with thinset mortar and fiberglass reinforcing tape.
May 11, 2017
Yes, it is perfectly o.k to screw the backer board to you walls using sheetrock screws or the cement backer board screws. Like someone said earlier, be sure to attach the backer boards to your studs using 1 1/4 to 1 5/8 inch drywall screws. If you are installing the backer boards over sheet rock, it is still perfectly o.k to screw the boards using screws, once again, be sure to aim to hit you studs. One thing to look out for is your plumbing on your shower assembly side of your shower, you can do this by marking all your studs, before you begin any screwing. Good luck.
May 11, 2017
Yes, you can screw them directly to the wall studs. That is the only way that they will have the proper support.
May 11, 2017
Yes, the screws will not affect the tiles. Just make sure that the screws are in all the way.Hope that helps.Good luck
May 11, 2017
slightly one does no longer extremely breathe even as contained in the uterus - it is residing in a fluid filled ecosystem. It takes this is first breath even as that is further. even as contained in the uterus, it survives by using the indisputable fact that is suitable to the mummy by the umbilical cord. It is going to the lavatory corresponding to everybody, yet in straight forward words pee. This comes from swallowing amniotic fluid. It does no longer poop even as contained in the uterus except now and again on the very end (meconium) which could genuinely pose plausible if the toddler were to inhale it earlier or in the time of start.
May 11, 2017

Share to: