My TV satellite receiver is of medium size, so I'd like to ask you all of the experts who can help me explain why there are 30% signals and 78% signal quality. But that is not the image, the original idea is because the head does not match the decoder, but replaced the original factory or the same. Try using an old fashioned head, and change with polarization.......... Look at the master to answer, thank you very much!!
There is no signal on the upper star, so there is no signal quality.The signal strength only shows that the equipment is good. Only when the signal quality "%" value and a certain value can be received. The stars are not only monotonic, but also need to adjust the elevation angle. Adjusting the satellite antenna according to the procedure is the azimuth, elevation and polarization angle of the satellite to be collected.The settings in the machine are also important. One step wrong will not be adjusted.
Even the machine broke. It is impossible to find professionals to debug.Connect the signal line, turn on the TV and receiver, then see the working picture of the satellite receiver, the machine will automatically scan the program, if not, you will be prompted to receive the program zero. At this time the key information, would see the two stop number indication, a signal strength (probably in 40%), following a signal quality (alignment satellite indicator will become long, some will turn green, said lock program, numbers above 30%), the antenna alignment west south west the position of the slow about moving up and down, while moving changes while watching the quality of signal strength, if a variable length or flash, and that this position is the satellite position, in this position repeatedly, until the maximum signal quality will be successful.
Signal quality 30% is a little small, re adjust antenna azimuth and elevation angle. LNB polarization angle to the signal quality of the maximum value, and then click search automatically!
