Why is the number 980 CNC lathe turret always turn and then alarm
Tool holder is always unable to find the knife position, usually 24 or 0 volts knife restIf it is a station can not find the detection switch is broken
What is the alarm? If the information is only in the parameters of the interface will not be canceled after the pop-up bar. If the alarm is always there must be an alarm number.
There are several reasons:1: Holzer component line failure.2: magnetic steel and Holzer yuan collision.3: Holzer component short circuit.4: turret motor three-phase inversion or phase.5: Holzer components and magnetic steel dislocation. Fifth faults appear more. Not really put the Holzer component for the. Also look at the turret controller is not a fault.
