Why is the rotation direction of the input shaft and the output shaft of the cycloidal pin gear reducer the same direction?
Hello, planetary cycloid reducer inside it is in low speed output process of revolution in the inside of one tooth difference, no gear changes its direction, as you look at the internal structure, and so of course is the same to the motor, good luck... Please help the adoption.
The cycloid pin gear reducer is a novel transmission device that uses the planetary transmission principle and uses cycloidal gear teeth to mesh. The whole drive device of the cycloid pin gear reducer can be divided into three parts: the input part, the deceleration part and the output part. Double eccentric sleeve is provided with a dislocation of 180 degrees on the input shaft, the eccentric sleeve is provided with two known as the roller bearing of the rotary arm, formation mechanism, H two is the center hole of the cycloid raceway of bearing eccentric sleeve, and by a group of pin tooth cycloidal gear and annular arrangement the needle on the gear meshing, to form a tooth for tooth difference internal gear reducer, (in order to reduce friction, gear ratio in small, with a needle tooth pin gear).
When the input shaft with an eccentric sleeve to rotate in a week, because of the characteristics of the cycloidal gear teeth profile and the needle tooth limit of the needle gear, cycloid motion become both plane motion and rotation of the revolution, the input shaft rotates week, eccentric sleeve also rotates a circle, cycloid gear to "the opposite direction" turned a tooth to decelerate, and then using the W output mechanism, cycloidal wheel rotation speed will be through a pin shaft, is transmitted to the output shaft, so as to obtain the output low speed.
