Why should the high pressure hydraulic tube peel off the outer skin?
Reasons for stripping:1, the inner diameter of the sleeve is a standard series, and a little rubber hose is not suitable for sizing.2, after stripping, the sleeve can be directly pressed on the steel wire layer, the connection is reliable, and it is not easy to pull out.
There are two reasons for stripping. One is that the inner diameter of the sleeve is the standard series, and that the outer diameter of the hose is not suitable, so it must be peeled. Two, after stripping, the sleeve can be directly pressed on the steel wire layer. The connection is reliable, and it is not easy to pull out.Whether or not to peel the rubber depends on the fit between the hose and the sleeve. Not every rubber hose is to be stripped.
Skinning requirement:The stripping length of hydraulic hose shall be two to four mm shorter than the caseA layer without peeling, more than two layers stripped to see the steel wire, otherwise the shell is easy to fall offThe size of the joints to be installed depends on the size of the joint and the quality of the hose, just start recording more to find the most suitable size.
High pressure hose is generally relatively thick, there are steel wire layer, the purpose of peeling is to connect the tooth and steel layer close combination, the joint is more solid. But not all high-pressure hose needs peeling. Now many large companies do not need peeling. For example, pike.
