Home > categories > Electrical Equipment & Supplies > Flow Switches > Wiring Principle and Diagram of Target Flow Switch
Question:

Wiring Principle and Diagram of Target Flow Switch

Wiring Principle and Diagram of Target Flow Switch

Answer:

working principle: Target-type (baffle-type) flow switch for the detection of unidirectional or two-way flow of air, oil and water, the media should not have winding debris. When the fluid flow through the pipeline, the baffle deflection, by adjusting the adjustment bolt, so that the single-pole double-throw micro switch in the set flow on the action, the output switch signal; two-way detection, the baffle offset push the magnetic module up, Module action. Used to detect unidirectional flow of air and water, water should not have winding debris. When the fluid flows through the pipe in the indicated direction, the baffle is deflected. By adjusting the mediation bolt, the single-pole double-throwing microswitch is activated on the set flow and output the switching signal. Set the flow range, easy to adjust Widely used for water, gas, oil and other media measurement. The principle of the wiring of the target flow switch and the figure are as follows: 1 to the end of the line, the output according to the requirements of normally open when the election 3 or select the normally closed 4.
May 9, 2017
And the user does not need to install and wiring the site, also to avoid the installation of the target water flow switch is not accurate lead to the unit
May 9, 2017

Share to: