Home > categories > Construction & Real Estate > Veneers > Wooden door with veneer ruled, pattern is produced by different cutting methods
Question:

Wooden door with veneer ruled, pattern is produced by different cutting methods

Wooden door with veneer ruled, pattern is produced by different cutting methods

Answer:

According to the data of the broadleaf plywood and veneer association, the standard cutting method for the veneer used in the market is as follows
Jun 9, 2017
Rotary Cut - Install the logs in the center of the lathe, insert the knife at a slight angle, and then rotate the logs against the slicer to create a revolving veneer
Jun 9, 2017
Sweep veneer can be wide to provide the whole board (single) board.
Jun 9, 2017
Plain Slicing (Flat Slicing, Flat cut) - also known as flat cut, flat slices / plain film, string cut veneer is the section of the knife along the center of the parallel line
Jun 9, 2017
cut out the wood. From the cut off the logs cut off the veneer, the first layer of the ring will form a "cathedral" type of pattern grain.
Jun 9, 2017

Share to: