10 (6) /0.4kv three-phase transformer what does it mean
Therefore, the decision to 60 and 35kV winding connection to be careful when the connection must meet the transmission system voltage phasor requirements. The connection between 60 and 35kV windings is determined according to the relative relationship of the voltage phasors. Otherwise, even if the capacity of the voltage ratio is also right, the transformer can not be used, connected wrong, the transformer can not be connected with the transmission system. 3). Domestic 10,6,3 and 0.4kV transmission and distribution system phase also has two phases. In the Shanghai area, there is a 10kV and 110kV transmission system voltage phase difference of 60 ° electrical angle, this time can be used 110/35 / 10kV voltage ratio and YN, yn0, y10 connection three-phase three-winding power transformer, but limited Three-phase three-core core. 4). But note that: single-phase transformer in the combination of three-phase group connection, can not use YNy0 connected three-phase group. Three-phase shell-type transformer can not use YNy0 connection.
Three-phase five-column core transformer must be used YN, yn0, yn0 connection, in the transformer must be connected into the angular connection of the fourth winding, it is not out of the beginning (the structure to do the electrical test when the lead is not This case). 5). When the transformer of different connection group is running in parallel, the general rule is that the connection group label must be the same. 6). When the distribution transformer is used in the multi-mine area, the Yzn11 connection method can be used. When the z-connection method is adopted, the impedance voltage algorithm is different from the Yyn0 connection method, and the copper consumption of the z-way winding is more. Yzn11 connection distribution transformer lightning protection performance is better. 7). Three-phase transformer with four volumes when the core frame can not be used YNy0 connection. 8). These are used for the domestic transformer connection, such as the export should be required to supply the appropriate connection and connection group label. 9). Generally in the high-voltage winding are connected with the tap-changer. Therefore, when selecting the on-load tap-changer (including the on-load tap-changer and the off-circuit tap-changer), it must be noted that the transformer connection and the on-load tap-changer (including connection, test voltage, rated current, Level voltage, voltage range, etc.). YN connected to the on-load tap-changer used on-load tap-changer, it is also important to note that the midpoint must be able to lead.
?The answer is recommended by the questioner
