The drawing is 10 mm wide, 25 long and 13. deep, and there is a hole 8 mm in diameter. It is opened at length 6 mm and 25 mm deep. It has been opened.The previous masters are all milling, and the sizes are controlled by 10 mm and 10 filaments. How did he do it? How does the runout of the spindle of vertical milling head relate to the school?
You can use 8 mm keyway milling rough milling, and then use 10 mm end milling, milling, it is best to correct the vertical milling head spindle before beating.
Available in 8 mm keyseats rough milling cutter, with 10 mm fine milling, according to selection of speed, precision and rigidity of milling machine cutting, machining inspection before the best corrected vertical milling head spindle runout etc..
General Mills od as keyseats high precision milling groove size as well as keyway milling, if drawing on slot size precision is relatively high, should use the keyway milling keyway milling cutter
