The two valves are available for the flow of the electromagnetic valve switch, I contact more, found for water solenoid valve are caged water, to repair several times because of impurities or newly installed pipeline with raw materials flowing through the valve, close the valve body when not to rely on Yan, a seepage water tank to diffuse phenomenon!I am looking for a replacement, I think the electric valve should be a good choice, not used to a conclusion.Please use the electric ball valve to talk about friends, or for the two kinds of friends who have an understanding to talk aboutOr there is no better substituteThere seems to control the solenoid valve and electric valve is not the same, the solenoid valve is normally open and closed to control the electric valve is controlled by the trigger (like), if used to replace it, what is the controller?
Solenoid valve on the medium cleanliness requirements are very high, when the water is not clean, easy to leak. You use the solenoid valve is leaking, that's the case.If you have an air source, use pneumatic angle seat valvesIf only the power supply, the electric ball valve.Electromagnetic valve is electromagnetic rail, electric suction from the electromagnetic core, so that the valve openThe electric ball valve is driven by the motor to drive the valve open. If only switch, then do not need to install any controller, when buying, must explain is the switch ball valve.This answer was net friend adoption
I think you should use the solenoid valve is diaphragm type, and not particularly good products, diaphragm solenoid valve in the closed position when the diaphragm is easy to change, resulting in pipe die, or medium impurities caused the pilot hole is blocked, the valve will not move, so the diaphragm solenoid valve. Is there a film guide card member, so that each position of the diaphragm in the correct position, but the pilot hole is not a solution, of course, you can use direct action solenoid valve, such problems are solved. The electric ball valve than the pilot solenoid valve in this respect, but the cost of this fear is much higher, especially the pipe diameter is not so, it does not pay!
