After the installation of the small satellite TV receiver, why is there no signal?
Hello. With 58% of the signal strength, it shows that your connection is normal. In the 58 case {} become reason in your present position is not installed properly, is generally south by west point, elevation is very low, you can slowly try to turn the pan position, if the signal strength can be up to 65%. It means that the location is aligned, and then slowly move up and down, slowly moving the position of the pot. When the quality of the following ENB signal appears green, it means that the satellite is up. After that, move the pan slowly in this position. When the signal quality up to 50% of the time, you can fix your pot, the receiver off your menu, all OK, thank you.
Take the satellite receiver to the South and adjust slowly. Be patient.
The reason is in your pot position is not installed properly, is generally south by west point, elevation is very low, you can slowly try to turn the pan position, if the signal strength can be up to 65%. It means that the location is aligned, and then slowly move up and down, slowly moving the position of the pot. When the quality of the following ENB signal appears green, it means that the satellite is up. After that, move the pan slowly in this position. When the signal quality up to 50% of the time, you can fix your pot, you can turn off the receiver menu.
There is no video signal solution for satellite TV receivers:1, check whether the signal source line contact is bad, leading to no signal, such as antenna signal input, receiver, receiver and TV connection circuit, to ensure that the line is smooth and firm.2, second, check whether the satellite antenna's orientation changes, you can re tune the star, to ensure a stable signal quality and signal strength, and then try to search taiwan.
3, and then check the TV signal source is properly switched mode, such as receiver through an AV cable connection, the signal source should be switched to AV mode, the receiver will display screen, otherwise there will be no signal.4, if the above methods after the investigation, still no video signal may be satellite antenna fault, fault or failure caused by the TV receiver, it is recommended to contact the corresponding customer service service for maintenance can be resolved.
