I choose the air conditioner is installed by GREE, GREE is responsible for customer service, because of the distance, to extend the brass 5 meters, do not know whether it will affect the cooling effect, at the same time will be extended to ask is part of the welding up, or directly use a whole copper pipe, an extension pipe and the machine comes in quality are the same, thank you!
The extension of the copper, the refrigerant to append a certain amount (refrigerant), the installation of the master know; if you can change into a whole copper pipe is the best, GREE general standard 3 meter tube, if not, use the welding quality, slightly, as long as the installation of the master does not pit you, no problem.
It would be better to use the whole pipe if the conditions permit, but the price is very expensive. Welding can also, copper tube quality is almost the same, GREE itself does not produce copper pipe, but also outside the procurement. Refrigerant in the extension pipe after the need to add in proportion, otherwise it will affect the effect.
Influence is not great, just 10 metersAs for the extension or use of a whole root, it is necessary to consider the skills of the master and the quality of the copper tubes used
1, air conditioning copper tube to be extended is normal, generally does not affect the cooling effect, (of course, not unlimited extension)2, will be extended part of the welding up, pay attention to add insulation insulation pipe. (this saves, but adds two possible leaks). If possible, use a whole copper tube directly.3, extension tubes and machines come with, should ensure that the quality and diameter of the same, insulation insulation tube thickness can be.
Can be extended, you need right angle bending treatment can be as follows:Pay attention to the following matters to install air conditioning tubes: 1, ready to meet the need of welding equipment and accessories and air conditioning pipe. 2, must clean air conditioning fittings and brass welding, so as to ensure the correct spot. , 3 air conditioning to make corresponding cutting brass markers, using copper knife cutting copper tube for air conditioner. 4, with both ends of cloth or gauze cleaning air conditioning pipe, until it looks clean. This is done to remove dirt and grease and prevent oxidation. 5, when welding the use of air conditioning air conditioning copper flux, only a thin layer of copper flux can be. In 6, heating air conditioning copper tube and pipe fittings, pipe fitting is to be more heat, so the installation of air conditioning fittings and brass should be hot enough.
