Altium designer DXP transformer in the same name how to change?
I am only familiar with PROTEL, PROPERTIES I am not familiar with
The same name is a painting of about 2-3mil radius of the solid circle, can not directly change, must be copied from the source file to the schematic library file can be changed, that is, to re-create schematic symbols.
You can re-draw one, you can also copy the source file in the transformer to change it. As for the PROPERTIES you said in the EDIT PINS NAME option, that is only your name to the pin, help to understand. For example, a transformer with only one primary edge and one secondary side, and the same name (two points of the graphics port) are located in the top, 1,2 pin on behalf of the original side, 3,4 pin on behalf of the secondary, Or 2,4) is the same name. 1,2 PIN (PIN) name (NAME) were Pri +, Pri-; 3,4 pin were Sec +, Sec-. Obviously here pri and sec are primary and second abbreviations, namely the primary and secondary, and +, - can be understood as positive and negative, can also be understood as the same as + (or -) at both ends of the same name.
Transformer with the name of the most obvious label is the graphics on the two points. You in the schematic after the change and then on the line.
I am also doing this, need to change the same name. You can exchange.
