Angle valve removal and installation
4., products should be installed level, flexible opening, smooth flow of water, the connection should be tight, no leakage.5. do not use corrosive substances to clean products.6. products should be installed by professionals to prevent barbaric construction!An angle valve is not much money, and bad for another, you can buy more angle valve standby
Angle valve installation:1 before installation, should confirm the product surface without sand holes and threaded pipe wall thickness uniformity, rotating flexible switch.2. before installation, the water pipe should be cleaned once, and no residue or residue in the water pipe is confirmed, so as not to affect the water.3., the product can not be directly hand fastened to the water pipe interface, because of the uneven force of the hand may cause damage or cracks in the product.
.Installation steps of single hole water tap:Step 1: remove all copper fixed base.Step two: screw the nut counterclockwise from the threaded pipe.Step three: hose, wear yellow spanner, nut, threaded pipe, silicone pad.Step four: cross the hose through the containers to be installed (sinks, basins, etc.) pay attention to: silicone pad in the vessel installation at both sides of each piece, and finally tighten, can be fixed more stable.Step five: the small end of the hose is screwed into the faucet inlet by hand and screwed until it is screwed. It does not need to be screwed by other tools.Step six: screw the threaded tube into the lower side of the faucet. The silicone pad on the side of the vessel can be placed under the faucet.Step seven: nut fixing faucet, screw nut can be tightened, installation completed.
