Home > categories > Construction & Real Estate > Tile > any ideas on how to get grout of my tile floor?
Question:

any ideas on how to get grout of my tile floor?

i was pouring grout on my tile floor and it dryed too fast. how can i get rid of it?

Answer:

Sand it off. The upper layers should be fine but you'll have trouble the closer to the tile you get. You don't want to scratch that new tile. A quick tap from a chisel may release it from the tile surface but you runt the risk of cracking the tile. Good luck!
Scrape off exess with a sharp hardwood stick, Don't use metal, it will scratch the tile. Then use a burlap bag. It will shine it right up. Works great !
forget the scrubbing except you're extremely into it. flow to Lowes or domicile Depot, spend the money and placed money right into a Shark steam air purifier. I genuinely have wiped sparkling each and every of the grout between the tile flooring decrease back to their unique colour in under an hour. The steam dissolves the airborne dirt and dust and pushes up onto the tile and you purely wipe away. the toughest ingredient to do is stand there and factor the steam nozzle. you will locate many different makes use of for the steam air purifier around the domicile additionally. It cleans indoors and out. My acquaintances are all testing my air purifier and then procuring their very own. Seal the grout when you get it wiped sparkling.
You didn't mention how thick it was. You might be able to very carefully chip it off with a putty knife if thick. if just a thin layer try laying a very wet sponge on top of it, it may loosen it to where you can wipe it up. This is what you should have done in the first place. When grouting you do small section at a time, wipe the grout into the tiles with a sponge and then wipe up the excess and go on to another area. You can do about 3 square feet at a time. All ways have a bucket of water handy for this purpose.
Moisten the joints between the tiles with a little bit of water. This makes the grout naturally flow into the crevices and away from the face of your tile. Work in small sections, cleaning the surface of the tile as you go. The longer you wait, the more the grout will set and the harder it will be to remove. Clean the tiles with a damp sponge. After you apply the grout to the joints of the tiles, use a damp sponge to wipe the surface of each tile clean. You may want to go over it a few times to make sure that no excess grout remains. Sweep all the grout to one area, and then wipe it with a rag if necessary. Find a pH balanced cleanser. If grout or residue still remains on the tile, use a gentle cleaner to scrub the surface. If you left the grout on too long and it cured on the tile, you may need an acid-based solution.

Share to: