A few seconds after my computer was switched on, I switched to a the Great Wall power test. But the two power models are different, the current is also different, in which the current of 5V is larger than 9V. Can it be used instead?The computer was originally powered by delta power: 200W, Delta, GPS-200ABA, REV (version), 02F3.3V---11A, 5V---12A, 12V---12A, 5VSB---2A, -12V----0.5AThe Great Wall power supply is: 300W, the Great Wall, ATX-300P4-PFC, 2+1, full function protection3.3V---14A, 5V---21A, 12V---14A, 5VSB---2A, -12V----0.3A, put awayThe Great Wall power supply is old-fashioned interface, if it can be used, plus an interface conversion line can be?There is a mistake on it. The current of the line of the Great Wall power supply 5V is big. Can 9A do that?
No problem at all. The power supply is universal. The power supply voltage of various standard interfaces is standard, and the current is large,All power supplies have different interfaces and different power. As long as the interface is right and the power meets the demand of the total power of the computer, it can be used. Not limited to brands and models.You know, all the assembly machines are generic parts (compatible), otherwise they will not be called assembly machines.
This is possible, a small output voltage, could not move your host, if so long, but not good for the host, as a big power, some of the
First, look at the volt parameters of the power mark:+12V generally provides power for hard disks, optical drives, floppy drives, spindle motors, and track motors.The voltage of the -12V is to provide the logic level for the serial port+ 5V power is supplied to the working voltage of CPU and PCI, AGP, ISA integrated circuit, the computer is the main work of power supply.The -5V also provides a level of judgment for the logic circuit3.3V provides power for the memory.+ 5VSB (+5V standby power) ATX power supply through the PIN9 to the main board + 5V720MA power supply, this power supply for the WOL (Wake-upOnLan) and boot circuit, USB interface and other circuits to provide power.Power supply = the number of volts corresponding to the sum of Andouble, so the greater the output current safety factor, indicating that the power of this power is higher.Only when the power supply rated power is greater than the actual power computer, the computer can run normally, the original 200W power supply used for a long time after the aging caused by lower output power and boot a few seconds off, a change of 300W the Great Wall is normal is the reason.
