Artificial stone how to remove the plastic
1, with a paper towel dip some alcohol (preferably with industrial alcohol) to wipe, and then rub a few times on the clean.
2, with acetone. The method is the same as above.
3, with nail polish. Usage is also the same as alcohol acetone. The effect is also very good. Wash water does not require quality,
4, with hand cream. First tear the surface of the printed products, and then squeeze some of the hand cream on the top, slowly rub with a thumb, rub a while will be able to stick to the residual sticks are rubbing down. It is a little slower. Hand cream is a lipid material, its nature and glue is not compatible.
5, with banana water. Is used to remove the paint of an industrial agent, it is easy to buy (selling paint where there is to sell).
1, with an eraser along the edge of a little bit to rub, easy to mark. But depending on your degree of sticky, it may be time different. If conditional alcohol + eraser effect is very good.
2, you can take a piece of vinegar covered with dry cloth, to cover the entire double-sided adhesive traces of the place, until the double-sided adhesive sticky stains completely wet, you can use the ruler easily removed.
3, you can also use the heating method to double-sided adhesive glue softening: blowing with a hair dryer to soften the glue, when the double-sided adhesive adhesion becomes weak, you can easily remove.
Artificial stone mainly to look at the next type of installation is left or otherwise, if it is installed when the first to eradicate the thicker place after the use of acetone to clean up. Note that when wiping with a good glove, because acetone is a chemical easy to damage the skin.
