As for the floor tile, marble, please joint groove to fill the soil with lime or cement to fill. Three, the original floor if the thickness of the wooden floor to be more than 12MM, there can be no bending, deformation or cracking phenomenon, such as to see the nail head must be buried in the wood. Four, the original floor if the cement can not have sand, bump or turn the situation. As for the new cement shop must be completely dry before construction, must be more than two weeks in the summer, winter will be around in the above, such as cold and wet climate will slow the rate of drying.
Tools: a knife blade, remove the plastic floor flat at room temperature for at least 24 hours, two on each side of the wall to find the center point, draw the cross center line on the floor, the ground is divided into four areas, and then from the central to the laying of three four, clean the ground, make sure the ground can begin after the laying of four, clean (without gum floor) with a scraper coated plastic tile special adhesive, five (Beijiao floor) tore the floor backing off the paper, starting from the six floor of the center line laying in all directions, each piece of tile must be close to the junction, glued to the ground, to avoid the gap seven, laying to the wall the floor tile cutting required size
Tools: a knife blade, remove the plastic floor flat at room temperature for at least 24 hours, two on each side of the wall to find the center point, draw the cross center line on the floor, the ground is divided into four areas, and then from the central to the laying of three four, clean the ground, make sure the ground can begin after the laying of four, clean (without gum floor) with a scraper coated plastic tile special adhesive, five (Beijiao floor) tore the floor backing off the paper, starting from the six floor of the center line laying in all directions, each piece of tile must be close to the junction, glued to the ground, to avoid the gap seven, laying to the wall the floor tile cutting required size
