My automatic mahjong table conveyor belt how to reverse the motor, it should be up to send the card, and now it will pass down the card, resulting in the card simply do not get on, the magnetic circles suck the cards are gone, Do not say anything more
A little bit of light control problems! Two open cover sunshine! Three mahogany cards are dirty!
If the other function is normal no big problem, the relay is broken, for one. But there may be problems with the main control board. Because the motor relay is in the master
Have you ever been repaired? According to what you said, I made a look at the analysis, please refer to: First, as the first floor said, continued electrical (capacitor) is broken, you can change a high-power, but the motor will have some sound, can barely use. Or directly replace the motor Second, the conveyor belt dirty, mahjong table conveyor belt motor with a reverse function, if the belt is dirty, forward belt does not move, it leads to reverse. You can spray Billy beads on top of the belt to try, it is best to wash mahjong. Third, the motherboard is broken, it is more complex, motherboard circuit problems, according to the brand you buy, find manufacturers to replace the general warranty. Fourth, K4 light sensor for, resulting in not read the card, paint about the light, that is, on the licensing device, there are two small bulb-style stuff. You can also adjust its sensitivity to try. Fifth, the mahjong table this stuff, fear of tide, pay attention to keep dry. Sixth, if the above method no longer, mahjong table with automatic detection file, you can adjust to the detection file, automatic detection, according to the instructions. If not, it is best to find a professional. This is my personal point of maintenance experience, hoping to help you. for reference only.
