I was painting my friend's warlock for him so I had taken everything off of it (bridge, knobs, etc.) except for the pickups. I didn't want to reinstall the pickups because I've never done that before. But as fate would have it, the pickup wires snapped during the whole painting process and now I have to solder them back in somehow. Does anybody know of any websites that explain how to install pickups? Unless, of course, it's so easy that you can explain it to me right here. Thanks a ton.
Well try peeling back a little bit of the plastic covering on the wire . this will make soldering easier. Next check where you are going to make your connection. It should be kinda clean (free from paint) Then heat up a soldering gun and get your solder. You might come out easier if someone else takes a pair of tweezers and holds the wire in place . basically heat the solder over the connection point untill a small amount drops in place. It should cool and seat wire where you want it. If not just heat the solder back up a little and remove wire and start process over again
