Bathroom door lock is broken, want to open to repair it. But the two handles removed, and found that the cylinder is locked with a rivet on the door, I do not know whether the destruction of the case without breaking the cylinder? In addition to this lock core can repair it? Thank you!
Usually the aluminum alloy is too thin when the connection strength is too low, for the use of rivet or rivet nut can greatly improve the connection strength. Rivet nuts can be easily disassembled using threaded connections, but the cost is too high. Pull rivet cost is low, the strength can be guaranteed, but not easy to disassemble.
If you have a corner mill is very convenient.
Disassembly method:
Remove the inside and outside of the two handle panel: the screw in the handle on the panel, the top one, the following one.
2. Remove the inside and outside the lock cylinder cap: screw in the house lock on the cap, that is, plug the left and right sides of the key.
3. Lock the cylinder positioning screw: the screw on the side of the door, in the middle of the lock, with the same height cylinder. The thickest is that.
4. At this time you can remove the old lock cylinder: the old and new lock cylinder, you can replace the.
Install new lock cylinder:
Order and split the opposite, pay attention to the following points:
1. Before installing the new lock cylinder, add a small amount of lock cylinder to the new lock cylinder dedicated lubricant. Repeat the lap with the key.
2. Cylindrical positioning screws must be tightened to prevent the screw after the opening is not good to open the door.
3. Lock the cap screw Do not twist particularly tight, to prevent the call, bad unlock.
4. When installing the inner handle panel, there is a fuse at the bottom, insert the corresponding fuse.
This thing belongs to a product. Can only put the two hat worn out to take out. The other side of the iron can be pulled out.
Usually the aluminum alloy is too thin when the connection strength is too low, for the use of rivet or rivet nut can greatly improve the connection strength. Rivet nuts can be easily disassembled using threaded connections, but the cost is too high. Pull rivet cost is low, the strength can be guaranteed, but not easy to disassemble. If the angle grinder is very convenient.
