Bathroom wall stickers finished, the wall is not reserved, the suite door can be installed
It is entirely possible.
In recent years, aluminum doors (aluminum, aluminum), including the bathroom dedicated flat door, has now changed the door to stay in the past a considerable standard defects (but the wall must be vertical, the hole on both sides of some errors will not be affected) The Because there are now with the mouth of the aluminum door, both sides are available on both sides. Manufacturers will be that you measure the size of the processing, not worry.
It is recommended that if the smaller bathroom (especially the distance between the door near the shower), the use of aluminum doors. Wooden door is not a long time.
There is no problem with the set of doors (instructed to do the installation).
Yes, the general to do a fake sets on the line
can.
Set Door Installation Tips:
1, the installation of wooden doors, the first check the doors of the various parts are complete, the size of the parts are correct, assigned to the corresponding position to the corresponding position is consistent with the door.
2, the goods to be installed on the ground level, do not lean to rely on. No paint products should be painted within five days. Try to avoid outdoor sunshine for a long time to prevent the doors heated.
3, to keep the indoor air circulation, to prevent the frequent moisture of the wooden doors. To prevent the wooden doors from the normal impact, not too much should not force too much. It is forbidden to hang heavy objects on the door. Corner wall, T-wall before the installation of the door should be notified to customers in the first side of the stack without "false wall", the width of the size of not less than 50mm, according to the width of the line to determine the "false wall" width of the size of the number, Both sides show asymmetrical door edges.
4, single fan flat open the door, the mother door, double fan door opening hole size (set plate thickness of 32mm): height of the door 2080mm = door height 2030mm + plate thickness 35mm + distance from the ground 15mm, door width 900mm = Width 830mm + (2 * plate thickness 35mm). Other types of combination doors are subject to the specific circumstances (note: the height of the hole is the height of the hole from the ground has been done, the width of the hole, the thickness is the net size).
