Bearing seat processing what lathe, as far as possible to say specific points, not to the phone line, the adoption must be re - thank
If there is no rule, there are four claws, which is correct.
The bearing seat processing center according to high margin of bearing seat to estimate turning diameter, selection of ordinary lathe on the line such as C620, C630 etc..When machining, a disc is needed, and then a 90 degree right angle bending plate is clamped. The bending plate is provided with a screw hole for mounting the pressing plate.The bearing seat to be processed is clamped on the 90 degree right angle bending plate, the pressure plate is pressed, the bearing seat is adjusted, the bearing hole is arranged, the center is coaxially connected with the rotating center of the machine tool, and the pressing plate is tightly fastened, and the processing can be started. Note that in general lathe machining bearing, cutting speed is not too high, not too large, the workpiece must be fastened.
The chuck can be used as long as it can be clamped.
