I am doing starch based Blister products, and just started production. In the production process, found that the finished products have static electricity, attached to many dust. Ask an expert how to deal with it!
The material is heated in the plastic mould and melted and cooled gradually. But because of static electricity, will lead to deformation or adsorption of dust, and affect the quality of products.
The best solution is to add JIENS electrostatic eliminator in the process of plastic suction, such as JIENS ion fan. Blowing in advance prevents static electricity from occurring and static electricity that is produced can be removed immediately.Of course, if the conditions permit, buy a CR-2 electrostatic tester to detect the size of electrostatic voltage, which is the best.Contact me if you have any questions.
Can use ion wind bar or ion fan to eliminate static electricity, of course, some blister machine will also use ion wind mouth and so on. Commonly used are ion wind sticks, because the ion bar is small, easy to install, and the speed of static electricity is also good. But the life of the ion wind bar is shorter than that of the ion fan, so if it can be installed, it is better to use the ion fan installed in the thermoplastic forming machine.The principle of installation is: where the electrostatic impact is, the electrostatic eliminator (ion fan, ion wind bar, etc.) of the air outlet aligned at the impact of a little bit on the line. Make sure you're a little ahead! Specific can refer to PIFAPO electrostatic network on the use of different electrostatic eliminator and usage.
