Bought last year's cabinet, outside the layer of protective film for a long time, can not tear down, how to do?

Answer:

3 shovel to the edge, hand tear, tear the edge of the corner can not be scraped with a corner of the card.Note: when blowing with a blower, the time should not be too long, the card processing attention to moderate, so as not to scratch the surface of the cabinet.

Hello, I was doing the whole cabinet, this should be torn off, you should be a UV paint, or molded plate, if the tear is molded is no problem, if it is paint it, you can choose a relatively small door with nails off a little bit, it would not take off paint, if not even though you expose, and if you are Aluminum Alloy edge it is best to use the wallpaper knife along the variable scratch Aluminum Alloy, and then open it,Of course, if paint it will expose, when holding the cuticle! You try!

2 use scrap cards (such as bank cards, advertising cards and other thin cards) to shovel along the torn sides;

First use the hot air blower, and then use the card shovel1 use a hair dryer blowing hot air on the protective film protective film with ten or so, the hand ripped a hole;