Brick machine operating procedures
When the material in the feeder barrel is not filled with the depth of the packing, find the drain plate below the cylinder and pour the remaining material from the cylinder, and then close the feed motor.
When working properly, keep the material in the feeder barrel at a height of 1 / 2-3 / 4. When it is found that the press is not working properly, should immediately stop the inspection, and troubleshooting. The machine is stopped and the press is stopped during normal operation.
Check the electrical part of the fault and leakage phenomenon. Check if the packing concentration is appropriate. Check the triangle belt tightness is appropriate. After the motor is fed to the upper part of the cylinder, open the material gate, so that the material flow to the feeding body cylinder, at this time presses began to work.
Before the car is ready for work, check and clean the surface of the turntable, the mold hole and the various parts of the movement on the debris. For each lubrication point must be added enough oil.
When the material in the rotary disk die hole is completely pressed, the main motor is turned off and the brick waste in the mold hole is cleaned. If you stop for a long time, you should disconnect the current. After stopping, should be the machine moving components of the connection bolts, oil cups, bearings and other preventive checks.
