Calcium silicate board production line
Flow slurry method is equipped with a stirrer and separator in the headbox. When the slurry reaches a certain level in the headbox, it flows naturally through the horizontal cloth pulp plate and the inclined flow slurry plate to the blanket to form the initial material layer, The initial material layer through a number of vacuum box forced dehydration, winding to the forming tube I, to achieve the required thickness from the molding tube after pulling the wet blank, the next process into a variety of products.
Calcium silicate board production line by the ingredients machine, pulp machine, slurry tank, mixer, plate machine, blank machine, stripping machine, steam curing machine, dryer and milling machine, with the conveyor, conveyor composition Complete fiber reinforced calcium silicate board production line. The production line with high efficiency, low energy, high capacity, economic and reasonable advantages.
The method of copying is to flow the prepared slurry into the cage through the slurry tank, and the slurry is submerged to about 3/4 of the diameter of the reel, and the outer ring is wrapped with a certain number of internal and external networks. The upper part of the wheel set with a roll of blankets and blankets in contact with the wheel, running, the chest roller rotation to drive the blanket running, the passive roller rotation while driving the rotation of the wheel, the slurry in the role of pressure through the reel filter, Layer attached to the net outside the net, because the net is a porous and can be through the air, and the fog roll, blanket and material layer between the more dense, no air can be passed, so the material layer more easily from the reel to the wool , Thin primary layer was continuously passed on the blanket. The stirrer is used to prevent the slurry from settling, and the heavy sand debris sinks to the bottom of the tank and is periodically removed by the release plate of the floor. The material layer through the vacuum box after dehydration, winding to the forming tube, to achieve the required thickness from the molding tube after pulling off the wet blank, the next process into a variety of products.
