Home > categories > Minerals & Metallurgy > Aluminum Foils > Can anyone solve these I can't solve it! plz help?
Question:

Can anyone solve these I can't solve it! plz help?

Can anyone solve this? 1Identify what is _ and what is _ in the redox reaction of aluminum and ironIdentify the and the _The words in the side are : Redox and Electronegraivty Oxidation Reductions reactions10 Points to the best answer!

Answer:

Some fleece can be trickyTry a 90/14 ball point if that is not what you are usingAlso experiment with other needlesBe absolutely certain the needle is inserted correctly and everything is threaded properlyRather than experiment on flannel, experiment on fleece scraps, as they sew nothing alikeYou may need to change the upper or lower tension (in tiny increments), the pressure, and/ or the stitch length.
The first thing you should is consult your sewing machine manualWhen I first started learning to sew, and had thread nesting under my fabric, a consult with my manual told me I had inserted the bobbin into the case, incorrectlyI had also wound the thread onto the bobbin incorrectlyI corrected both, and everything started working correctlyI will venture a guess your tension/stitch length needs to be adjustedCheck to make sure your machine is threaded properly, also, and with a decent quality thread; no cheapy stuff (i.e2/$1.00) here.Coats Clarke, at least.
Take each and every of the thread off the appropriate suited of the device, reset the top rigidity to 4 and raise THE PRESSER FOOT till now THREADINGThis opens the top rigidity, and the thread can unquestionably get into the rigidity disksFloss it in to make advantageous this is seated interior the rigidity diskAfter that, you are able to decrease the presser foot so this is much less stressful to string the needleLoops on the backside of the fabric recommend the appropriate suited thread has little or no rigidity; loops on the appropriate suited of the fabric recommend the bobbin thread has little or no rigiditygeneric top rigidity placing proper for many fabric is 4.
If the machine was sewing fine before the needle broke and not now then you don't have the needle in right or your needle is too smallMake sure your needle is a size 14 or biggerIt is printed on the needle going up the needleThe flat part of the needle should be against the post that comes down from the machineSometimes that is towards the back and sometimes it is towards the sideWhoops I see that you said it was the right size so it must be the placement of the needleIt could also be that when the needle broke it dislodged some of the way the top thread was threaded in the machine so check that tooIt might be a good idea to rethread the machine
work out where the electrons are going if something is losing electrons then it is being oxidisedGaining electrons then it is being reduced.

Share to: