Can I put up wall tiles on the bathroom wall waterproof cloth?
Water repellent. By mixing cement mortar waterproof agent in the kitchen or bathroom at the grassroots level to do it again, after the dry, use waterproof admixture cement ash in the first layer on the brush layer, which is mainly for the first time will be generated through the dry hole blocked after, there is the root of the pipeline should be carefully brush.
Non-woven fabric, which is similar to a cloth that will base with cement mortar thin brush layer, it can be directly laid on the top.1, note: these three, no matter what kind of waterproof, around 300-500 higher than the ground to prevent water flowing along the wall to the following:1, brush the first waterproof coating. Before construction, make sure that the site is clean and dry, waterproof paint should be painted, no missing, and firmly integrated with the base, no cracks, no bubbles, no shedding phenomenon. Brushing height is consistent, the thickness should meet the product specification requirements.2, brush second times waterproof coating. Note that the first and second times waterproof paint between the need for a certain time interval, the first time after the dry coating can be carried out second times, the specific time depends on the paint. Interval time is too short, waterproof effect will be greatly reduced.3, laying protective layer. To prevent subsequent construction damage to the waterproof layer, it is necessary to put a protective coating on the surface of waterproof coating. The protection layer should be covered with waterproof layer without any omission. It is firmly integrated with the base layer, without cracks, no bubbles and no shedding.
With the coil, first clean the base, so that the base drying, and then roll on the ground, with the spray gun heating coil, is between the coil and coil gap bonding. But the material is relatively fragile, the surface is easy to break in when the gravel backfill and the pipeline root and Water Leakage, not very good treatment.
