Can the bypass of the overhanging layer on the site be made of channel steel? How can I put the channel steel, if possible?
JGJ130 2016.10.6 when the cantilever beam and the structure of the steel plate bolt connection fixed suspension type steel, steel plate size should not be less than 100mm * 10mm (width * thick); when the bolt angle plate connection, angle specifications shall not be less than 63mm * 63mm * 6mm.
The cantilever end of 6.10.7 steel cantilever beam shall be provided with a fixed point which can make the scaffold stand firmly with the steel beam. The location shall be no less than 100mm at the end of the cantilever beam. When the 6.10.8 anchor position is set on the floor slab, the thickness of the slab shall not be less than 120mm.
6.10.11 wall fittings shall be in accordance with the provisions of section 6.4 of this code. The main structure of 6.10.12 anchor steel shall not be less than C20
Reinforcement measures shall be taken if the floor thickness is less than 120mm. 6.10.9 the cantilever beam spacing shall be set by the vertical distance of the vertical pole of the cantilever frame, and each vertical distance shall be provided with one root. 6.10.10 the outer bracing of the cantilever shall be set up from bottom to top. The scissors support shall comply with the provisions of articles 6.6.2 and 6.6.5 of this code.
